|
Look for links to printable pdf
literature in equipment specifications sections, above in this column, & on
site map.
| |
InFlow W125 Accessory for IQAir Air
Purifiers
Technical Specs Sheet (pdf)
|
Printable
InFlow W125 Product Brochure
The
InFlow W125 ducting kit enables any IQAir filtration system to draw air
through a wall or window vent into an indoor environment. Use of the InFlow
W125 is advisable when the main pollution source is located in adjacent
indoor environments or outdoors.
Enjoy controlled clean air ventilation
An IQAir® filter system combined with an InFlow W125 can be
installed to draw outdoor air into an indoor environment. In this setup, an
IQAir serves as a ventilation system, bringing in oxygen-rich outdoor air
and a filtration system, which removes undesirable outdoor pollutants such
as pollen, mold spores, dust and exhaust soot. As a result, fresh and
filtered outside air comes into the room. |
|
Create clean positive pressure areas
An IQAir® filter system combined with an InFlow W125, which draws
air into a room will in most cases allow the creation of a positive pressure.
This positive pressure helps to clean the air in a room by constantly flushing
out air pollutants and by preventing outside pollutants from entering the room.
Application Examples
 |
Protection of allergy
sufferers from pollen exposure in their home
|
|
|
Protection of patients
from microbiological exposure (e.g. aspergillus) in a hospital
|
|
|
Creation of clean
research or manufacturing areas (controlled environments)
|
|
|
Protection of plant
control rooms from corrosive contaminants
|
|
|
Creation of a clean
zone within a home or office which helps to prevent outdoor pollution from
nature, factories, traffic, agriculture to enter.
|
Using an InFlow W125 with an
IQAir system can improve indoor air quality by:
|
|
diluting polluted air
with clean air |
|
|
flushing out air
pollutants |
|
|
reducing influx of new
outside pollutants due to a build-up of positive pressure
|
|
|
by increasing oxygen
content in indoor air (when outdoor air is being drawn in)
|
Installation
The InFlow W125 kit can be easily added to any IQAir filtration
unit in a matter of minutes. As regards the building, the only modification
required is a 5” hole in a window, wall or door which allows you to connect the
InFlow W125 aluminum duct.
The duct may be freely flexed to allow control over the desired vent location.
It is expandable in length, from 10” in its original compressed state, to 39”
when fully extended.
IQAir Compatibility
Compatible with all IQAir filtration devices.
Not compatible with the accessories PF40, VMF, VM FlexVac, VM InFlow and FlexVac.
Click Here for more
information
|
